If you have been reading about lyophilised powder and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2026-07-10. Where a claim depends on a specific study, the study is described rather than over-claimed.
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The regulatory position is broadly consistent across major jurisdictions: no thymosin beta-4 fragment is an approved medicine, and laboratory material is commonly labelled as not intended for human consumption. Anti-doping rules in sport list thymosin beta-4 and its fragments among prohibited peptide hormones. Because these products travel through research-chemical channels rather than pharmaceutical supply chains, quality varies considerably between vendors. Independent testing of identity, purity and sterility is the only dependable check, and a certificate of analysis describes one batch rather than a supplier's whole catalogue.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Calculated for the acetylated heptapeptide |
| Molecular weight | ~889 Da | Monoisotopic mass approximately 889.0 Da |
| Amino acid sequence | Ac-LKKTETQ | N-terminal acetylated seven-residue peptide |
| Appearance | White to off-white powder | Typically supplied as a lyophilized solid |
| Solubility class | Water-soluble | Peptides of this size generally dissolve in aqueous media |
TB-500 is a synthetic peptide preparation marketed under a name derived from thymosin beta-4, a 43-residue actin-binding protein first isolated from thymus tissue. The full-length protein has a reported molecular mass near 4963 Da, while material sold as TB-500 is often described as a fragment containing the actin-binding motif LKKTETQ. Because suppliers use the name inconsistently, published sources sometimes refer to the same label as a fragment, a synthetic copy, or a related analog. This naming ambiguity complicates direct comparison of reports across studies.
Laboratory work on thymosin beta-4 describes binding to monomeric actin and effects on cell migration, angiogenesis, and inflammatory signaling in cultured cells. Animal models have examined skin, corneal, and cardiac repair after injury, with outcomes reported mainly in preclinical literature. Most of that evidence concerns the parent protein rather than preparations labelled TB-500, so extrapolation from animal findings to a specific commercial product remains uncertain. Whether the two behave identically in living systems has not been established in controlled human studies.
No major regulatory agency has approved TB-500 for therapeutic use, and it holds no pharmacopoeial monograph. The name appears on the World Anti-Doping Agency prohibited list within the class covering peptide hormones, growth factors, and related substances. Detection in doping control relies on mass spectrometric methods applied to urine, often after preparation steps that concentrate the analyte. Discussion of TB-500 therefore clusters in biochemistry, sports medicine, and anti-doping literature rather than in registered clinical trials.
TB-500 is a research peptide whose sequence matches residues 17 to 23 of thymosin beta-4, a 43-residue protein present in most mammalian cells. The chain is seven amino acids long, written as LKKTETQ, and is normally supplied with an acetyl group on the N-terminus. Suppliers list it as a lyophilised powder under the code name TB-500, and the same sequence appears elsewhere in catalogues as the thymosin beta-4 actin-binding fragment. The label is commercial rather than systematic, so no single authority fixes exactly what TB-500 denotes.
Thymosin beta-4 was isolated from calf thymus in the early 1980s and later characterised as an abundant intracellular actin-sequestering protein. Interest in short synthetic fragments grew once the actin-binding motif had been mapped to the middle of the sequence. TB-500 came out of that line of work as a truncated analogue rather than a natural isolate, and it is now sold mainly to laboratories. Published studies on the fragment have been largely in vitro or in animal models, and controlled human trials remain sparse, so claims about effects in people rest on extrapolation.
Literature and online discussion often conflate TB-500 with full-length thymosin beta-4, even though the two differ in size and are not interchangeable in analytical terms. The fragment is produced by solid-phase peptide synthesis, and the product is a defined seven-residue chain rather than a biological extract. Because the term is a trade-style label, two vendors may supply materials of the same nominal sequence but different counter-ion content, purity, or water content. Comparisons across studies are therefore difficult unless the exact sequence and purity are reported.
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
In chemistry, particularly in biochemistry, a fatty acid is a carboxylic acid with an aliphatic chain, which is either saturated or unsaturated. Most naturally occurring fatty acids have an unbranched chain of an even number of carbon atoms, from 4 to 28. Fatty acids are a major component of the lipids (up to 70% by weight) in some species such as microalgae but in some other organisms are not found in their standalone form, but instead exist as three main classes of esters: triglycerides, phospholipids, and cholesteryl esters. In any of these forms, fatty acids are both important dietary sources of fuel for animals and important structural components for cells.
== Limitations of mechanical micronization == Although mechanical micronization is the most widely used industrial technique, the high specific energy delivered by milling can alter the solid-state properties of the active beyond simple size reduction. The most extensively documented consequence is partial conversion of crystalline material to the amorphous state at the newly created particle surfaces. Because the amorphous state has higher free energy, greater hygroscopicity, and faster dissolution than the parent crystal, surface amorphization can shift dissolution behaviour, accelerate moisture uptake, and recrystallize uncontrollably during storage — altering the very properties micronization was performed to achieve. Mechanical stress can also drive polymorphic conversion between crystalline forms or induce conversion from anhydrous to hydrated phases (and vice versa). The thermodynamic driving force is provided by the cumulative mechanical energy absorbed by the lattice; in some cases the milled product passes through an amorphous intermediate before recrystallizing into a different polymorph than the starting material. Because different polymorphs and hydrates have different solubility, dissolution rate, and bioavailability, mill-induced polymorphic conversion is a critical quality attribute that must be monitored by techniques such as X-ray powder diffraction, differential scanning calorimetry, and Raman spectroscopy.
==== Drugs ==== A number of medications have been identified which may cause hypoglycemia, through a variety of ways. Moderate quality evidence implicates the non-steroidal anti-inflammatory drug indomethacin and the anti-malarial quinine. Low quality evidence implicates lithium, used for bipolar disorder. Finally, very low quality evidence implicates a number of hypertension medications including angiotensin converting enzyme inhibitors (also called ACE-inhibitors), angiotensin receptor blockers (also called ARBs), and β-adrenergic blockers (also called beta blockers). Other medications with very low quality evidence include the antibiotics levofloxacin and trimethoprim-sulfamethoxazole, progesterone blocker mifepristone, anti-arrhythmic disopyramide, anti-coagulant heparin, and chemotherapeutic mercaptopurine. If a person without diabetes accidentally takes medications that are traditionally used to treat diabetes, this may also cause hypoglycemia. These medications include insulin, glinides, and sulfonylureas. This may occur through medical errors in a healthcare setting or through pharmacy errors, also called iatrogenic hypoglycemia.
Patrick Pierre Sabatier, La pomme de terre, c'est aussi un produit diététique, Robert Laffont, 1993, 275 p. (ISBN 2-221-07631-1). Racines, tubercules, plantains et bananes dans la nutrition humaine, FAP, coll. « Nutrition », no 24, Rome, 1991 (ISBN 92-5-202862-5). Joël Robuchon et Patrick Sabatier, Le Meilleur et le Plus Simple de la pomme de terre, Robert Laffont, 1994, 250 p. (ISBN 2-253-08159-0).
Sources: en.wikipedia.org
=== Corneal crystallins === Similar to lens, cornea is a transparent, avascular tissue derived from the ectoderm that is responsible for focusing light onto the retina. However, unlike lens, cornea depends on the air-cell interface and its curvature for refraction. Early immunology studies have shown that BCP 54 comprises 20–40% of the total soluble protein in bovine cornea. Subsequent studies have indicated that BCP 54 is ALDH3, a tumor and xenobiotic-inducible cytosolic enzyme, found in human, rat, and other mammals.
distillation The process of separating the component substances of a liquid mixture by exploiting differences in the relative volatility of the mixture's components through selective boiling and subsequent condensation. The apparatus used to distill a substance is called a still, and the re-condensed substance yielded by the process is called the distillate.
== Chemical mechanism == An important goal of measuring enzyme kinetics is to determine the chemical mechanism of an enzyme reaction, i.e., the sequence of chemical steps that transform substrate into product. The kinetic approaches discussed above will show at what rates intermediates are formed and inter-converted, but they cannot identify exactly what these intermediates are. Kinetic measurements taken under various solution conditions or on slightly modified enzymes or substrates often shed light on this chemical mechanism, as they reveal the rate-determining step or intermediates in the reaction. For example, the breaking of a covalent bond to a hydrogen atom is a common rate-determining step. Which of the possible hydrogen transfers is rate determining can be shown by measuring the kinetic effects of substituting each hydrogen by deuterium, its stable isotope. The rate will change when the critical hydrogen is replaced, due to a primary kinetic isotope effect, which occurs because bonds to deuterium are harder to break than bonds to hydrogen. It is also possible to measure similar effects with other isotope substitutions, such as 13C/12C and 18O/16O, but these effects are more subtle. Isotopes can also be used to reveal the fate of various parts of the substrate molecules in the final products. For example, it is sometimes difficult to discern the origin of an oxygen atom in the final product, since it may have come from water or from part of the substrate.
Sources: en.wikipedia.org
TB-500 is a synthetic heptapeptide corresponding to a fragment of thymosin beta-4. It is used in laboratory research and is not an approved drug.
No. Thymosin beta-4 is a 43-amino-acid protein, while TB-500 represents only a short N-terminal segment. The two should not be treated as interchangeable in experimental design.
It is often called a thymosin beta-4 fragment, Tβ4 fragment, or Ac-LKKTETQ. The name TB-500 is mainly a commercial or catalog label rather than a formal chemical name.
Desiccated storage at −20 °C is conventional, with −80 °C for extended periods. Vials should be warmed to room temperature before opening to prevent condensation on the powder.