Everything below concerns peptide mapping. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2026-02-07. Where a claim depends on a specific study, the study is described rather than over-claimed.
TB-500 is a synthetic seven-amino-acid peptide with the sequence LKKTETQ, corresponding to residues 17 through 23 of the protein thymosin beta-4. The N-terminus is typically acetylated in the described form, giving a monoisotopic mass near 888.5 Da and an average mass of about 889 Da. The designation TB-500 is a catalogue label rather than a formal chemical name, and the same sequence appears in the literature under several alternative abbreviations. It is handled as a research reagent rather than a pharmaceutical product.
Thymosin beta-4 is a 43-residue actin-binding protein found in most mammalian cell types, where it participates in cytoskeletal regulation and cell migration. TB-500 represents only a short fragment of that protein and does not include the remaining residues. Whether the isolated fragment reproduces the full range of activities reported for the intact protein remains an open question. Researchers commonly treat the two as related but distinct entities when comparing results.
Published work involving this sequence spans actin-binding assays, cell-migration studies, wound-healing models, and cardiovascular or musculoskeletal experiments. Much of the biological rationale derives from in vitro systems and animal models, and the number of controlled human studies is small. Reported outcomes vary across preparations, doses, and routes, which complicates comparison between studies. Reviews generally describe the evidence base as preliminary rather than settled. Mechanistic explanations are often proposed by analogy to the parent protein rather than demonstrated directly.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
Purity is normally assessed by reversed-phase HPLC, with the main peak reported as a percentage of total peak area, while identity is confirmed by mass spectrometry. Electrospray and MALDI-TOF instruments are both used, and the observed mass is compared with the value calculated from the stated sequence. Ion-exchange or size-exclusion methods appear where aggregation or charge variants are of interest. Water content, counter-ion content and residual trifluoroacetate from purification are separate variables that can shift the measured mass and should be weighed when reading a certificate of analysis.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Acetylated heptapeptide form |
| Monoisotopic mass | 888.5 Da | Average mass about 889 Da |
| Appearance | White to off-white solid | Usually supplied as lyophilised powder |
| Solubility class | Highly water soluble | Also dissolves in aqueous buffers |
| Common synonyms | Tbeta4 fragment, thymosin beta-4 (17-23) | Refer to the same sequence |
Lyophilized peptide powder is normally held desiccated at −20 °C, with −80 °C used for longer storage periods. Allowing a sealed vial to reach room temperature before opening is standard practice, because condensation forming on cold powder introduces moisture. Once dissolved, solutions are typically kept cold and shielded from light. Repeated freeze-thaw cycles are avoided because they encourage aggregation and gradual loss of material. These conventions are general to synthetic peptides rather than unique to any one sequence.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The regulatory position is broadly consistent across major jurisdictions: no thymosin beta-4 fragment is an approved medicine, and laboratory material is commonly labelled as not intended for human consumption. Anti-doping rules in sport list thymosin beta-4 and its fragments among prohibited peptide hormones. Because these products travel through research-chemical channels rather than pharmaceutical supply chains, quality varies considerably between vendors. Independent testing of identity, purity and sterility is the only dependable check, and a certificate of analysis describes one batch rather than a supplier's whole catalogue.
The fragment most often associated with the name carries the sequence Ac-LKKTETQ, matching residues 17 through 23 of thymosin beta-4. That region holds the actin-binding motif responsible for much of the parent protein's biochemical activity. Apart from N-terminal acetylation the peptide is unmodified and contains no disulfide bonds, so it shows little ordered secondary structure in solution. Full-length thymosin beta-4 is instead a 43-residue polypeptide of roughly 4.9 kDa found widely across mammalian cell types.
Material sold under this label typically arrives as a freeze-dried powder in a sealed vial with a certificate of analysis. Such certificates usually report reversed-phase chromatography purity plus a mass confirmation, and stated purities commonly sit between 95 and 99 percent. Counter-ion identity, residual trifluoroacetate, water content, and peptide net weight are separate specifications that a certificate may or may not include. A purity figure alone does not establish sequence identity, so independent mass verification remains the practical check.
The designation TB-500 circulates in laboratory and catalog contexts without a single agreed definition. Most product listings apply it to an N-terminally acetylated seven-residue fragment of thymosin beta-4, while other listings attach the same label to the full 43-residue protein. Because the term is commercial rather than systematic, two entries bearing identical names may describe different molecules. Any documentation should therefore state which sequence a given sample is claimed to contain.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
Lyophilised peptide powders are hygroscopic, and the fragment absorbs atmospheric moisture when a vial is opened at room temperature. Weighing and aliquoting are normally done quickly in a dry environment, and stock solutions are divided into single-use portions before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and can shift the measured content of a vial. These practices are general to synthetic peptides rather than unique to this sequence, but they matter more for short chains kept for long periods.
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
Abortive initiation is a normal process of transcription and occurs both in vitro and in vivo. After each nucleotide-addition step in initial transcription, RNA polymerase, stochastically, can proceed on the pathway toward promoter escape (productive initiation) or can release the RNA product and revert to the RNA polymerase-promoter open complex (abortive initiation). During this early stage of transcription, RNA polymerase enters a phase during which dissociation of the transcription complex energetically competes with the elongation process. Abortive cycling is not caused by strong binding between the initiation complex and the promoter.
Some groups of people have specialized transfusion requirements. Fetuses, very low-birth-weight infants, and immunocompromised people are at risk for developing severe infection with cytomegalovirus (CMV)―an opportunistic pathogen for which approximately 50% of blood donors test positive―and may be transfused with CMV-negative blood to prevent infection. Those who are at risk of developing graft-versus-host disease, such as bone marrow transplant recipients, receive blood that has been irradiated to inactivate the T lymphocytes that are responsible for this reaction. People who have had serious allergic reactions to blood transfusions in the past may be transfused with blood that has been "washed" to remove plasma. The history of the patient is also examined to see if they have previously identified antibodies and any other serological anomalies. A direct antiglobulin test (Coombs test) is also performed as part of the antibody investigation. Donor blood is generally screened for transfusion-transmitted infections such as HIV. As of 2018, the World Health Organization reported that nearly 100% of blood donations in high- and upper-middle-income countries underwent infectious disease screening, but the figures for lower-middle-income and low-income countries were 82% and 80.3% respectively.
The toxin has two subunits—designated A (mol. wt. 32000 Da) and B (mol. wt. 7700 Da)—and is one of the AB5 toxins. The B subunit is a pentamer that binds to specific glycolipids on the host cell, specifically globotriaosylceramide (Gb3). Following this, the A subunit is internalised and cleaved into two parts. The A1 component then binds to the ribosome, disrupting protein synthesis. Stx-2 has been found to be about 400 times more toxic (as quantified by LD50 in mice) than Stx-1. Gb3 is, for unknown reasons, present in greater amounts in renal epithelial tissues, to which the renal toxicity of Shiga toxin may be attributed. Gb3 is also found in central nervous system neurons and endothelium, which may lead to neurotoxicity. Stx-2 is also known to increase the expression of its receptor GB3 and cause neuronal dysfunctions. 2011 German E. coli outbreak Cholera toxin Enterotoxin Pertussis toxin
=== Other updates === On April 1, 2013, Valve implemented support for the Steam Workshop, which allows users to upload their custom-made assets onto the Steam community. These assets range from video game models and sound to animation project files. A version of the software for Valve's Source 2 engine, known as Source 2 Filmmaker, was released on May 15, 2020, alongside other development tools for Half-Life: Alyx. In February 2023, Facepunch announced they were producing their own successor to SFM due to compatibility issues with their own game platform, S&box. S&box, like Half-Life: Alyx, runs on the Source 2 engine.
Sources: en.wikipedia.org
==== Niccolò Figà-Talamanca ==== Niccolò Figà-Talamanca, the secretary-general of the NGO No Peace Without Justice, was one of the original four suspects arrested in the case. On 14 December 2022, Figà-Talamanca was released from prison with an electronic bracelet to track his movements, but the Belgian federal prosecutor successfully appealed the order on 27 December 2022, so Figà-Talamanca went back to prison. Figà-Talamanca was released from prison without conditions by the investigative judge at a hearing on 3 February 2023. Figà-Talamanca's lawyer at the hearings was Barbara Huylebroek. According to a member of his family, Figà-Talamanca remains charged.
Besides platformer gameplay, one of the game's most distinctive gameplay features is allowing to switch the player character's form to suit one's needs. The player begins the game as Maui, whose only means of self-defence is an insect-launching pistol that can launch several forms of bugs, some of them combined for greater effect. However, once the player reaches the second level, Maui transforms into Cold Shadow, his ninja alter ego, who defends himself with short-range attacks using a bo staff. Cold Shadow's staff is also primarily used to explore the level further, such as climbing a narrow tunnel. After the second level, the player can switch back and forth between Maui and Cold Shadow at will, provided he has enough ninja tokens for the transformation. The amount of ninja tokens Maui or Cold Shadow holds determines Cold Shadow's strength – who can then chain more and more attacks as his skill improves – when played as him in the SNES version. On Mega Drive, however, Maui needs to collect red ninja tokens instead, the amount of white tokens being useful for metamorphosis alone. Some levels of the game, however, prevent Maui from transforming at all, as Cold Shadow cannot bungee jump on vines, for example, which forces the player to use Maui throughout the level.
In that war, British submarines sank 2 million tons of enemy shipping and 57 major warships, the latter including 35 submarines. Among these is the only documented instance of a submarine sinking another submarine while both were submerged. This occurred when HMS Venturer engaged U-864; the Venturer crew manually computed a successful firing solution against a three-dimensionally maneuvering target using techniques which became the basis of modern torpedo computer targeting systems. Seventy-four British submarines were lost, the majority, forty-two, in the Mediterranean.
Sources: en.wikipedia.org
No. TB-500 is a short synthetic peptide matching residues 17 to 23 of thymosin beta-4, while the parent protein contains 43 residues. The fragment lacks the rest of the protein sequence, so the two are related but not identical.
It consists of leucine, lysine, lysine, threonine, glutamic acid, threonine, and glutamine in that order. The N-terminal leucine is usually acetylated in the forms described in catalogues.
Controlled human data is limited, and most published findings come from cell culture or animal work. This makes it difficult to state clinical effects with confidence.
Sealed, desiccated and protected from light, at -20 °C or lower for long-term storage. Short-term storage at refrigerator temperature is common in working laboratories.