thymosin beta-4 comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2026-05-27. Where a claim depends on a specific study, the study is described rather than over-claimed.
TB-500 is a synthetic seven-amino-acid peptide with the sequence LKKTETQ, corresponding to residues 17 through 23 of the protein thymosin beta-4. The N-terminus is typically acetylated in the described form, giving a monoisotopic mass near 888.5 Da and an average mass of about 889 Da. The designation TB-500 is a catalogue label rather than a formal chemical name, and the same sequence appears in the literature under several alternative abbreviations. It is handled as a research reagent rather than a pharmaceutical product.
Thymosin beta-4 is a 43-residue actin-binding protein found in most mammalian cell types, where it participates in cytoskeletal regulation and cell migration. TB-500 represents only a short fragment of that protein and does not include the remaining residues. Whether the isolated fragment reproduces the full range of activities reported for the intact protein remains an open question. Researchers commonly treat the two as related but distinct entities when comparing results.
Published work involving this sequence spans actin-binding assays, cell-migration studies, wound-healing models, and cardiovascular or musculoskeletal experiments. Much of the biological rationale derives from in vitro systems and animal models, and the number of controlled human studies is small. Reported outcomes vary across preparations, doses, and routes, which complicates comparison between studies. Reviews generally describe the evidence base as preliminary rather than settled. Mechanistic explanations are often proposed by analogy to the parent protein rather than demonstrated directly.
The designation TB-500 circulates in laboratory and catalog contexts without a single agreed definition. Most product listings apply it to an N-terminally acetylated seven-residue fragment of thymosin beta-4, while other listings attach the same label to the full 43-residue protein. Because the term is commercial rather than systematic, two entries bearing identical names may describe different molecules. Any documentation should therefore state which sequence a given sample is claimed to contain.
The fragment most often associated with the name carries the sequence Ac-LKKTETQ, matching residues 17 through 23 of thymosin beta-4. That region holds the actin-binding motif responsible for much of the parent protein's biochemical activity. Apart from N-terminal acetylation the peptide is unmodified and contains no disulfide bonds, so it shows little ordered secondary structure in solution. Full-length thymosin beta-4 is instead a 43-residue polypeptide of roughly 4.9 kDa found widely across mammalian cell types.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Acetylated heptapeptide form |
| Monoisotopic mass | 888.5 Da | Average mass about 889 Da |
| Appearance | White to off-white solid | Usually supplied as lyophilised powder |
| Solubility class | Highly water soluble | Also dissolves in aqueous buffers |
| Common synonyms | Tbeta4 fragment, thymosin beta-4 (17-23) | Refer to the same sequence |
Thymosin beta-4 contains 43 amino acids and has a reported molecular mass near 4963 Da. The short fragment most often associated with the TB-500 label, an acetylated chain beginning LKKTETQ, has a reported mass near 889 Da, so the two are easily separated in analytical work. Mass spectrometry and amino acid analysis can confirm which material is present in a given sample. Statements treating TB-500 and thymosin beta-4 as interchangeable are therefore imprecise, even though the two appear together in much of the same literature.
Interest in the compound comes largely from studies of the parent protein, which participates in actin sequestration, cell migration and tissue repair processes. Whether a short fragment reproduces those activities is a separate question that remains open in the published record. Many summaries describe mechanisms by analogy to thymosin beta-4 rather than from direct measurements on the fragment. Claims about activity should be treated as provisional unless a cited study specifies the exact peptide, its purity and the assay used.
TB-500 is a research peptide whose sequence matches residues 17 to 23 of thymosin beta-4, a 43-residue protein present in most mammalian cells. The chain is seven amino acids long, written as LKKTETQ, and is normally supplied with an acetyl group on the N-terminus. Suppliers list it as a lyophilised powder under the code name TB-500, and the same sequence appears elsewhere in catalogues as the thymosin beta-4 actin-binding fragment. The label is commercial rather than systematic, so no single authority fixes exactly what TB-500 denotes.
Thymosin beta-4 was isolated from calf thymus in the early 1980s and later characterised as an abundant intracellular actin-sequestering protein. Interest in short synthetic fragments grew once the actin-binding motif had been mapped to the middle of the sequence. TB-500 came out of that line of work as a truncated analogue rather than a natural isolate, and it is now sold mainly to laboratories. Published studies on the fragment have been largely in vitro or in animal models, and controlled human trials remain sparse, so claims about effects in people rest on extrapolation.
Literature and online discussion often conflate TB-500 with full-length thymosin beta-4, even though the two differ in size and are not interchangeable in analytical terms. The fragment is produced by solid-phase peptide synthesis, and the product is a defined seven-residue chain rather than a biological extract. Because the term is a trade-style label, two vendors may supply materials of the same nominal sequence but different counter-ion content, purity, or water content. Comparisons across studies are therefore difficult unless the exact sequence and purity are reported.
Dry peptide powder is commonly kept at −20 °C in a desiccated container away from light, a practice that limits moisture uptake and oxidation. Once dissolved, solutions are generally held at 2–8 °C for short periods or frozen at −20 °C or lower for longer storage, with repeated freeze-thaw cycles avoided. Hydrolysis and oxidation are the main degradation routes for peptides in solution, and both accelerate at higher temperature or extreme pH. Published stability data specific to TB-500 are limited, so shelf life should be treated as uncertain.
Identity and purity checks for peptide material typically combine reversed-phase high-performance liquid chromatography with mass measurement, since retention time alone cannot confirm a sequence. Mass measurement verifies the expected molecular mass within instrument tolerance, while chromatographic peak area provides a purity estimate. Anti-doping analysis of urine uses related but more sensitive workflows, sometimes after solid-phase extraction. For research material, batch documentation, certificate content, and independent testing are common points of scrutiny, because supply chains outside pharmaceutical regulation vary widely in the paperwork they provide.
Reconstitution of a lyophilized peptide is normally done with sterile water or a suitable buffer under aseptic conditions. Adding solvent down the vial wall and allowing gentle dissolution instead of vigorous vortexing reduces the chance of aggregation, which can lower the effective concentration of the resulting solution. Concentrated stocks are usually diluted into working buffer shortly before use. Because no standard preparation protocol exists for TB-500 specifically, laboratories adapt general peptide handling practice, and reported results may reflect differing preparation choices.
Hahn joined the new gas command unit at Imperial Headquarters in Berlin in December 1916 after travelling between the western and eastern front, Berlin and Leverkusen between mid-1914 and late 1916. Most of the students, laboratory assistants and technicians had been called up, so Hahn, who was stationed in Berlin between January and September 1917, and Meitner had to do everything themselves. By December 1917 she was able to isolate the substance, and after further work were able to prove that it was indeed the missing isotope. Meitner submitted her and Hahn's findings for publication in March 1918 to the scientific paper Physikalischen Zeitschrift under the title Die Muttersubstanz des Actiniums; Ein Neues Radioaktives Element von Langer Lebensdauer ("The Mother Substance of Actinium; A New Radioactive Element with a Long Lifetime"). Although Fajans and Göhring had been the first to discover the element, custom required that an element was represented by its longest-lived and most abundant isotope, and while brevium had a half-life of 1.7 minutes, Hahn and Meitner's isotope had one of 32,500 years. The name brevium no longer seemed appropriate. Fajans agreed to Meitner and Hahn naming the element "protoactinium". In June 1918, Soddy and John Cranston announced that they had extracted a sample of the isotope, but unlike Hahn and Meitner were unable to describe its characteristics. They acknowledged Hahn´s and Meitner's priority, and agreed to the name. The connection to uranium remained a mystery, as neither of the known isotopes of uranium decayed into protactinium.
Though crude oil is predominantly composed of various hydrocarbons, certain nitrogen heterocyclic compounds, such as pyridine, picoline, and quinoline are reported as contaminants associated with crude oil, as well as facilities processing oil shale or coal and have also been found at legacy wood treatment sites. These compounds have a very high water solubility and thus tend to dissolve and move with water. Certain naturally occurring bacteria such as Micrococcus, Arthrobacter, and Rhodococcus have been shown to degrade these contaminants. Because petroleum is a naturally occurring substance, its presence in the environment is not necessarily the result of human causes such as accidents and routine activities (seismic exploration, drilling, extraction, refining and combustion). Phenomena such as seeps and tar pits are examples of areas that petroleum affects without human involvement.
==== Officer of the Order of the British Empire (OBE) ==== Civil Division James Kepou. For services to the community and local Government Council. Henry Raisi Kila. For services to commerce and the community. Tembon Niki. For services to local government. Wilson Peni. For services to the community.
Sources: en.wikipedia.org
The company was founded in Pittsburgh, Pennsylvania, in 1902 by Chester Garfield Fisher (1881–1965), originally called the "Scientific Materials Co.". After obtaining his degree in engineering at Western University of Pennsylvania (now University of Pittsburgh), C.G. Fisher purchased the stockroom of the Pittsburgh Testing Laboratory. Fisher became a supplier of lab equipment and reagents for the area's industrial research. Early products included microscopes, burets, pipettes, litmus, balances, colorimeters, dissecting kits, and anatomical models. The first catalog, the 400 page Scientific Materials Co. Catalog of Laboratory Apparatus & Supplies, was published in 1904. Fisher established an R&D lab at his company in 1915. Edwin Fisher, Chester's brother, developed the Meker-Fisher burner in 1921, an advancement on the design of the Bunsen burner. The company manufactured an electric-combustion furnace and combustion train for analyzing carbon levels in steel, and an electrically heated and thermostatically controlled bacteriological incubator. In 1925, the company purchased Montreal-based Scientific Supplies, Ltd. The same year, the company was renamed Fisher Scientific. In 1940, Fisher Scientific acquired the New York supply company Eimer & Amend, which was founded in 1851 by Bernard G. Amend. Aiken Fisher, Chester's oldest son, became president of the company in 1949. In 1955, Fisher established a chemical manufacturing facility in Fair Lawn, New Jersey. In 1957, the company purchased the New York–based medical apparatus supply company E. Machlett & Sons.
Crossed Claisen condensations, in which the enolate and nucleophile are different esters, are also possible. An intramolecular Claisen condensation is called a Dieckmann condensation or Dieckmann cyclization, since it can be used to form rings. Esters can also undergo condensations with ketone and aldehyde enolates to give β-dicarbonyl compounds. A specific example of this is the Baker–Venkataraman rearrangement, in which an aromatic ortho-acyloxy ketone undergoes an intramolecular nucleophilic acyl substitution and subsequent rearrangement to form an aromatic β-diketone. The Chan rearrangement is another example of a rearrangement resulting from an intramolecular nucleophilic acyl substitution reaction.
Associated bone infections can include septic bursitis, septic tenosynovitis, and osteomyelitis. Septic arthritis and skin and soft tissue infections often present visible and/or systematic symptoms, while osteomyelitis usually presents localized pain.
=== Human β-casomorphin 7 === Structure: YPFVQPI Despite human beta-casein having a A2-like "P" after "I", human colostrum and early lactation-stage milk contains significant amounts of hBCM7. It is a much weaker opioid and the FVQ sequence renders it susceptible to further degradation.
Sources: en.wikipedia.org
No. TB-500 is a short synthetic peptide matching residues 17 to 23 of thymosin beta-4, while the parent protein contains 43 residues. The fragment lacks the rest of the protein sequence, so the two are related but not identical.
It consists of leucine, lysine, lysine, threonine, glutamic acid, threonine, and glutamine in that order. The N-terminal leucine is usually acetylated in the forms described in catalogues.
Controlled human data is limited, and most published findings come from cell culture or animal work. This makes it difficult to state clinical effects with confidence.
Usually not, though usage overlaps. The label most often refers to a short acetylated fragment of the parent protein, while thymosin beta-4 itself is the full 43-residue molecule. Because suppliers vary, a sequence statement is needed to settle the question for any particular lot.